774 Jacqueline drive, Garsfontein, Pretoria



Product Details


    [dispatch] => products.view
    [sl] => 
    [product_id] => 16367



Thermaltake Pacific RGB G1/4 PETG Fitting Kit - (6 Pack + Controller, 16mm OD/12mm ID)

Thermaltake Pacific RGB G1/4 PETG Fitting Kit - (6 Pack + Controller, 16mm OD/12mm ID)



available at supplier

Product description

Thermaltake Pacific RGB G1/4 PETG Fitting Kit - (6 Pack + Controller, 16mm OD/12mm ID)

Specially designed for enthusiasts to meet the needs of setting up a complete but stylish water cooling system. A RGB LED lighting controller is included. With a patented circular 256 multicolored LED light and made from durable copper, Thermaltake takes every detail seriously.

Patented RGB 256 Color LED Lights

The fitting comes with a specialy engineered LED light that can maintain color and brightness uniformity. The lighting effect is visible from all directions and adds style to your build. 

RGB LED Lighting Controller – Adjust LED Brightness

Users can adjust the illumination of the lighting into three different phases by pressing the “BRIGHTNESS” button.

RGB LED Lighting Controller – Switch Between 7 LED Colors

The “MODE” button allows users to switch to blink mode or set a solid color for the lighting. Users can choose from blue, green, red, white, orange, yellow and purple to brighten up their builds.

RGB LED Lighting Controller – Cycle Through 256 Colors

By simply clicking the “CUSTOMIZE” button, users can start to enjoy their liquid-cooling systems with a multicolored lighting show.

High-Flow and Leak-Free Design

Made in Taiwan, the fitting allows proper connection to G1/4 ports, securing properly to cooling components while providing an even seal around the tubing. The fittings include two pre-installed O-rings.


Compatibility: 16mm OD /12mm ID PETG hard tubing 

For tubes of Outer diameter: 5/8” (16 mm)

Fitting Dimensions: Ø25 x 31.4 H mm

Fitting Material: Copper

Thread: G ¼”

Kit weight: 720g

Includes 6x fittings and 1x LED Controller Box


Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.

Do not use tap water as your coolant, it may harm your loop and reduce performance.

Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.

DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately

Fill the reservoir to the top as it will prevent air from going into the pump

If necessary tilt the system slightly from side to side to bleed the air out of the loop.

Place some paper towels under fittings and joining points to test for leaks.

Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop

Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.

Coolant might fade over time.

Please note: For use with Thermaltake PETG (16mm OD, 12mm ID) components only! Check requirements before purchase! 

This kit is to be used together with other water cooling components in order to have a functional cooling system. 

Product Link

back to top

Join the conversation!